10CX085YU484I5G.pdf

This datasheet describes the electrical characteristics, switching characteristics, configuration specifications, and I/O timing for Intel® Cyclone® 10 GX devices. 

Intel Cyclone 10 GX devices are offered in extended and industrial grades. Extended devices are offered in –E5 (fastest) and – E6 speed grades. Industrial grade devices are offered in the –I5 and –I6 speed grades. 

Related Information 

Intel Cyclone 10 GX Device Overview Provides more information about the densities and packages in the Intel Cyclone 10 GX devices. 

Electrical Characteristics 

The following sections describe the operating conditions and power consumption of Intel Cyclone 10 GX devices. 

Operating Conditions 

Intel Cyclone 10 GX devices are rated according to a set of defined parameters. To maintain the highest possible performance and reliability of the Intel Cyclone 10 GX devices, you must consider the operating requirements described in this section. 

Absolute Maximum Ratings 

This section defines the maximum operating conditions for Intel Cyclone 10 GX devices. The values are based on experiments conducted with the devices and theoretical modeling of breakdown and damage mechanisms. The functional operation of the device is not implied for these conditions. 

Caution: Conditions outside the range listed in the following table may cause permanent damage to the device. Additionally, device operation at the absolute maximum ratings for extended periods of time may have adverse effects on the device.

Maximum Allowed Overshoot and Undershoot Voltage 

During transitions, input signals may overshoot to the voltage listed in the following table and undershoot to –2.0 V for input currents less than 100 mA and periods shorter than 20 ns. 

The maximum allowed overshoot duration is specified as a percentage of high time over the lifetime of the device. A DC signal is equivalent to 100% duty cycle. 

For example, a signal that overshoots to 2.70 V for LVDS I/O can only be at 2.70 V for ~4% over the lifetime of the device. 

(2) The maximum current allowed through any LVDS I/O bank pin when the device is not turned on or during power-up/power-down conditions is 10 mA. 

(3) Total current per LVDS I/O bank must not exceed 100 mA. 

(4) Voltage level must not exceed 1.89 V. 

(5) Applies to all I/O standards and settings supported by LVDS I/O banks, including single-ended and differential I/Os. 

(6) Applies only to LVDS I/O banks. 3 V I/O banks are not covered under this specification and must be implemented as per the power sequencing requirement. 

For more details, refer to AN 692: Power Sequencing Considerations for Intel Cyclone 10 GX, Intel Arria® 10, and Intel Stratix® 10 Devices and Power Management in Intel Cyclone 10 GX Devices chapter.